Skip to main content
Loading

IPv6 Configuration

Overview

Aerospike clusters can be configured to use IPv6 for both node-to-node and client-to-cluster connections.

This page describes prerequisites and relevant configurations. If you are planning to migrate your network to an IPv6-only environment, contact Aerospike Support for a smooth migration.

Required Network Setup for IPv6

  1. IPv6 enabled Linux OS.
  2. Site-local or global IPv6 address on an interface. Aerospike IPv6 does not support link-local addresses.

Sample configuration on a IPv6 enabled interface:

[citrusleaf@localhost serverlocal]$ ifconfig
eth1 Link encap:Ethernet HWaddr 00:0C:29:A9:DF:10
inet addr:172.16.1.128 Bcast:172.16.1.255 Mask:255.255.255.0
inet6 addr: 2001::1111/64 Scope:Global
inet6 addr: fe80::20c:29ff:fea9:df10/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:387 errors:0 dropped:0 overruns:0 frame:0
TX packets:324 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:34012 (33.2 KiB) TX bytes:31786 (31.0 KiB)

For the above, address "2001::1111" will work, because it's global. address "fe80::20c:29ff:fea9:df10" will not, because it's link-local. If your network is not IPv6-enabled and thus doesn't assign you an IPv6 address, you might still be able to work with IPv6 by manually assigning IPv6 addresses to machines. For this, the machines (clients as well as cluster nodes) need to reside in the same Ethernet segment.

Required Client

  • Java - version 3.3 and above.
  • C - version 4.10 and above.
  • C# - version 3.3 and above.

Additional Requirement

  • Available on Enterprise builds only.
  • advertise-ipv6 must be true.
  • Must be on heartbeat protocol version v3. Contact Aerospike support on upgrading to heartbeat v3 protocol.

Sample Aerospike configuration

service {
....
advertise-ipv6 true
}

network {
heartbeat {
....
protocol v3 // MUST follow instruction on how to switch over to hbv3 protocol.
}
}